2016 Volvo VNM: problems, recalls and reliability

Volvo Trucks North America (Volvo) is recalling certain model year 2012-2016 VNM trucks manufactured March 21, 2011, to April 30, 2015. Excessive engine crankcase pressures may cause the 90-degree elbow of the vent tube assembly to detach from the crankcase ventilation breather, possibly allowing engine oil to come into contact with hot surfaces.

Remedy: Volvo will notify owners, and dealers will secure the ends of the 90-degree elbow. In addition, the electronic control module (ECM) will be reprogrammed with software that can adjust the engine output under misfire conditions to limit crankcase pressures. These repairs will be performed free of charge. The recall began on June 12, 2015. Owners may contact Volvo customer service at 1-800-528-6586. Volvo's number for this recall is RVXX1502.

Volvo Trucks North America (Volvo) is recalling certain model year 2009-2010 VT trucks manufactured from April 9, 2008, through September 24, 2009, and certain 2016 model VNL and VNM trucks manufactured from January 2, 2015, through to November 6, 2015. The affected vehicles are equipped with USK non-greasable drag links that may experience corrosion of the ball joints due to the seals being compromised, possibly resulting in accelerated wear and failure of the ball joint.

Remedy: Volvo will notify owners, and dealers will replace the drag links, free of charge. The recall began on April 21, 2016. Owners may contact Volvo customer service at 1-800-528-6586. Volvo's number for this recall is RVXX1601. Note: This recall is an expansion of a previous recall 15V-651.

Volvo Trucks North America (Volvo) is recalling certain model year 2016-2017 VNL, VNX, and VNM trucks manufactured from May 11, 2015, through April 18, 2016. The trucks may have been manufactured without a roll pin on the steering shafts. If the roll pin is missing, the lower steering shaft may disconnect from the junction block. Also, the bolt connecting the upper steering shaft to the lower steering shaft may not have been properly tightened. Either condition can lead to separation of the steering shaft.

Remedy: Volvo is strongly recommending that the affected vehicles not be driven until the interim remedy is applied. An interim notice was sent to Volvo owners on March 16, 2016, and an interim repair is available now. A second notice was mailed on May 13, 2016. The final remedy is now available. Both remedies are free of charge. Owners may contact Volvo customer service at 1-877-800-4945 opt #1. Volvo's recall numbers for this campaign are RVXX1602 and RVXX1603. This recall supersedes safety recall 15V-786.

Volvo Trucks North America (Volvo) is recalling certain model year 2013-2017 VNL and VNM trucks and certain model year 2017 VNX trucks. In the affected vehicles, incorrect software for controlling the electronic air dryer may result in oil and water contaminating the brake system.

Remedy: Volvo will notify owners, and dealers will reprogram the vehicle control module and replace the air dryer filter, free of charge. The recall began on February 16, 2017. Owners may contact Volvo customer service at 1-800-528-6586. Volvo's number for this recall is RVXX1608.

Volvo Trucks North America (Volvo) is recalling certain 2016 Volvo VNL and VNM trucks equipped with certain Dana Spicer D-Series and E-Series steer axles. The castellated nut on the steer axles may not be properly torqued, allowing the tie rod to loosen.

Remedy: Volvo will notify owners, and dealers will inspect the torque of the castellated nut and tie rod, tightening it as necessary. If the tie rod stud and knuckle on units cannot be sufficiently torqued, the dealer will replace the knuckle and tie rod end assembly, free of charge. The recall began on October 17, 2017. Owners may contact Volvo customer service at 1-800-528-6586. Volvo's number for this recall is RVXX1702.