1999 Chrysler Sebring: problems, recalls and reliability
12 recalls and 264 owner complaints on record; the weakest area is structure (15% of complaints).
Data updated weekly · latest recall Dec 2010
All counts are reports filed with NHTSA in the United States - US market only, not worldwide totals.
Common problems
Computed from 264 owner complaints filed with NHTSA for this exact model year.
“Takata recall. I am having several issues with the whole braking system, as it is very difficult to pinpoint the exact cause of having no brakes. I have no type of brakes at all. When taken off parking, even with foot on brake, car will begin to move. This seems to be very common in these cars. The fuel pump was also replaced as it was letting less power go through. This happens as the car sits in parking, as well as, when driving. Also, the mechanic that looked at the car said that the pump needed to be replaced due to possible fire hazards. The lights flicker on and off by themselves, sometimes radio works, sometimes, lights get stuck on.”Owner report · Electrical System · Feb 2019
“Driving down road, around 10 miles a hour, the car suddenly went clunk on the left side, and would not move. Got out to check, and the entire piece that holds the tire on was laying on the interior of the tire rim.”Owner report · Suspension · Nov 2018
“Tl* the contact owns a 1999 chrysler sebring convertible. While driving 10 mph, the vehicle stalled and the check engine warning indicator illuminated. The contact stated that the vehicle restarted and the failure recurred. The vehicle was taken to the local dealer (chrysler jeep dodge ram 24, 1020 belmont st, brockton, ma, 02301) where it was diagnosed that there was a fracture in the camshaft timing and that the transmission failed. The vehicle was not repaired. The dealer stated that it was a safety hazard to work on the vehicle due to its condition. The vehicle could not be repaired. The manufacturer was not contacted. The failure mileage was approximately 170,000.”Owner report · Engine · Aug 2017
Show 7 more owner reports
“Tl* the contact owns a 1999 chrysler sebring. Prior to purchasing the vehicle, the contact was not informed by the dealer that the vehicle needed extensive repairs. The contact requested reimursement. The manufacturer was not notified. The failure mileage was 200,000.”Owner report · Electrical System · Sep 2016
“Car will stall at any speed. Will restart after about 15 tries. Happens after filling tank. 1st thought it was bad gas. But tried different stations. Same problem. Sporadic. Often happens when I shut off car and then attempt to start it again a few minutes later. Doesn't seem to be a problem when the car is cold. Very dangerous situation on high speed roadways. *tr”Owner report · Fuel/Propulsion System · Mar 2015
“Tl* the contact owns a 1999 chrysler sebring convertible. While driving approximately 15 mph, the front end of the vehicle collapsed to the ground. The vehicle was towed to an independent mechanic. The technician diagnosed that the front driver's side lower ball joint and axle fractured. The vehicle was not repaired. There was a recall under NHTSA campaign number: 09e056000 (suspension) however, the recall expired. The manufacturer was not notified of the issue. The approximate failure mileage was 129,000. The VIN was unavailable. Updated 10/3/2017*cn”Owner report · Suspension · Mar 2015
“Tl* the contact owns a 1999 chrysler sebring. While driving in reverse, the vehicle suddenly accelerated to an extremely high speed. The contact crashed the vehicle into the passenger side of another vehicle. A police report was not filed and there were no injuries. The vehicle was not diagnosed or repaired. The manufacturer was not made aware of the failure. The speed was unknown. The failure mileage was 155,000.”Owner report · Vehicle Speed Control · Sep 2014
“This car is a death trap and needs to be investigated. Car will lose all power, steering, and brakes while traveling at speeds up to 55mph. This is very dangerous and I almost killed myself because of this issue. I have taken the car to 3 mechanics and they cannot diagnose the problem. Chrysler won't even return my calls regarding the issue, which I've researched and found hundreds of others with this same problem. This is a huge safety hazard and chrysler should take responsibility for whatever it is that is causing this to happen. I'm wondering if I can take legal action against them. This is absolutely unacceptable. *tr”Owner report · Engine · Apr 2014
“Tl* the contact owns a 1999 chrysler sebring convertible. The contact stated that while driving approximately 50 mph, the vehicle stalled without warning. The vehicle was taken to a private mechanic where the failure was unable to be diagnosed. The manufacturer was notified of the failure. The vehicle was not repaired. The approximate failure and current mileage was 68,000.”Owner report · Engine · Apr 2014
“Tl* the contact owns a 1999 chrysler sebring. The contact stated that while driving approximately 3 mph, the vehicle became impossible to steer. The vehicle was taken to an independent mechanic who diagnosed that the ball joint was faulty. The manufacturer was notified of the failure. The failure mileage was 168,000.”Owner report · Suspension · Mar 2014
When filing, owners marked a crash in 34 of these complaints and injuries in 26 - self-reported to NHTSA, not verified accident statistics.
Recalls - 12 campaigns
QUALIS AUTOMOTIVE IS RECALLING CERTAIN AFTERMARKET BALL JOINTS SOLD FOR USE ON CERTAIN PASSENGER VEHICLES. THE SOCKET MAY HAVE BEEN EXCESSIVELY HARDENED WHICH COULD CAUSE IT TO CRACK NEAR THE RETAINING RING GROOVE ALLOWING THE BALL STUD TO SEPARATE UNDER IMPACT LOAD. THE SUBJECT BALL JOINTS WERE SOLD AS FOUR PART NUMBERS, D10945, D10946, G10945, AND G10946. THE AFFECTED CONTROL ARMS, D10945 AND D10946, ARE STAMPED WITH THE FOLLOWING DATES ON THE BALL JOINTS: 134308, 135708, 100109, 102709, 104109, 105509, 107609, 108909, 110309, 113209, AND 116609. THE G10945 AND G10946 ARE THE SAME PART AS THE D10945 AND D10946 RESPECTIVELY. THEY ARE LABELED DIFFERENTLY DEPENDING ON THE AFTERMARKET CUSTOMER.
Remedy: QUALIS AUTOMOTIVE WILL REPLACE THE BALL JOINTS FREE OF CHARGE. THE SAFETY RECALL BEGAN ON NOVEMBER 9, 2009. OWNERS MAY CONTACT QUALIS AUTOMOTIVE AT 1-800-493-4128.
CERTAIN TIGAS FUEL PUMP MODULES MANUFACTURED BETWEEN JUNE 1 AND SEPTEMBER 24, 2006, SOLD UNDER VARIOUS BRAND NAMES AND P/NOS. THESE FUEL PUMP MODULES ARE SOLD AS AFTERMARKET FOR USE IN CERTAIN DAIMLERCHRYSLER VEHICLES LISTED ABOVE. SILICONE MATERIAL USED IN MANUFACTURE OF THE FLAPPER VALVE WAS OUT-OF-SPECIFICATION, LEADING TO EXCESS SWELL OF THE FLAPPER VALVE RESTRICTING THE FLOW OF FUEL TO THE FUEL PUMP MODULE.
Remedy: TI AUTOMOTIVE WILL NOTIFY OWNERS AND REPLACE THE DEFECTIVE FUEL PUMP MODULES FREE OF CHARGE. THE RECALL BEGAN ON OCTOBER 6, 2006. OWNERS MAY CONTACT TI AUTOMOTIVE TOLL-FREE AT 1-877-461-1834.
CERTAIN AIRTEX FUEL PUMP MODULES, P/NOS. E7089M, E7094M, E7113M, AND E7129M, MANUFACTURED BETWEEN JUNE 1 AND SEPTEMBER 24, 2006. THESE FUEL PUMP MODULES WERE SOLD AS AFTERMARKET FOR USE IN CERTAIN DAIMLERCHRYSLER VEHICLES LISTED ABOVE. SILICONE MATERIAL USED IN MANUFACTURE OF THE FLAPPER VALVE WAS OUT-OF-SPECIFICATION, LEADING TO EXCESS SWELL OF THE FLAPPER VALVE RESTRICTING THE FLOW OF FUEL TO THE FUEL PUMP MODULE.
Remedy: AIRTEX WILL NOTIFY OWNERS AND REPLACE THE DEFECTIVE FUEL PUMP MODULES FREE OF CHARGE. THE RECALL BEGAN ON OCTOBER 18, 2006. OWNERS MAY CONTACT AIRTEX TOLL-FREE AT 1-866-867-3759.
THIS IS NOT A SAFETY RECALL IN ACCORDANCE WITH THE SAFETY ACT. HOWEVER, IT IS DEEMED A SAFETY IMPROVEMENT CAMPAIGN BY THE AGENCY. VEHICLE DESCRIPTION: PASSENGER VEHICLES. IF THE CONVERTIBLE TOP COVER IS NOT INSTALLED CORRECTLY, IT CAN SEPARATE UNEXPECTEDLY FROM THE VEHICLE WHILE DRIVING.
Remedy: OWNERS WILL RECEIVE AN IMPROVED CONVERTIBLE TOP COVER INSTRUCTION LABEL AND INSTALLATION INSTRUCTIONS.
IMPORT PRODUCTS IS RECALLING 30,351 FUEL FILTERS SOLD TO AND BRANDED BY THE AFFINIA GROUP AS CARQUEST P/N 86523, NAPA P/N 3523, AND WIX P/N 33523 FOR USE AS REPLACEMENT EQUIPMENT ON THE VEHICLES LISTED ABOVE. THESE FILTERS MAY DEVELOP A LEAK IN THE HOSE ASSEMBLY AND/OR CONNECTORS DUE TO IMPROPERLY ADHERED LINE CONNECTORS.
Remedy: THE AFFINIA GROUP WILL NOTIFY OWNERS AND THE FILTERS WILL BE REPLACED FREE OF CHARGE. THE SAFETY RECALL BEGAN ON AUGUST 1, 2009. OWNERS MAY CONTACT WIX FILTER RETURN CENTER AT 1-704-869-7411 OR IMPORT PRODUCTS AT 1-508-279-8207.
CERTAIN AIRTEX FUEL PUMP MODULE ASSEMBLIES, P/N E7081H, SOLD FOR USE AS REPLACEMENT EQUIPMENT FOR THE VEHICLES LISTED ABOVE. THE WALL OF THE FLARED FITTING OF THE FUEL PUMP IS NOT THICK ENOUGH TO PREVENT THE MATING THREADED FITTINGS FROM BOTTOMING OUT BEFORE AN ADEQUATE SEAL IS ACHIEVED. THIS CONDITION MAY RESULT IN LEAKAGE OF FUEL AT THE CONNECTION OF THE VEHICLE FUEL LINE AND THE FUEL PUMP MODULE ASSEMBLY.
Remedy: AIRTEX WILL NOTIFY OWNERS AND REPLACE THE FUEL PUMPS FREE OF CHARGE. THE RECALL IS EXPECTED TO BEGIN DURING JULY 2007. OWNERS CAN CONTACT AIRTEX AUTOMOTIVE AT 800-880-3056.
CERTAIN TRADESONIC COMBINATION LAMPS SOLD AS REPLACEMENT LAMPS FOR USE ON THE ABOVE LISTED PASSENGER VEHICLES. COMBINATION LAMPS NOT EQUIPPED WITH AMBER SIDE REFLECTORS FAIL TO CONFORM WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT.
Remedy: TRADESONIC WILL NOTIFY OWNERS AND REPLACE THE LAMPS FREE OF CHARGE. THE RECALL IS EXPECTED TO BEGIN DURING JULY 2006. OWNERS MAY CONTACT TRADESONIC AT 626-934-8884.
THIS IS NOT A SAFETY RECALL IN ACCORDANCE WITH THE SAFETY ACT. HOWEVER, IT IS DEEMED A SAFETY IMPROVEMENT CAMPAIGN BY THE AGENCY. VEHICLE DESCRIPTION: 1998-1999 CHRYSLER SEBRING JXI LIMITED CONVERTIBLES. THE STEERING COLUMN INTERMEDIATE SHAFT COUPLER PINCH BOLT RETAINING PIN COULD SNAG AND/OR FRAY THE EDGE OF THE DRIVER'S SIDE FLOOR MAT.
Remedy: DEALER WILL REPLACE THE STEERING COLUMN INTERMEDIATE SHAFT COUPLER PINCH BOLT AND RETAINING PIN. IN ADDITION, THE FRONT FLOOR MATS WILL BE REPLACED.
ON CERTAIN PASSENGER VEHICLES, THE FLOOR SHIFTER IGNITION-PARK INTERLOCK MAY FAIL AND ALLOW THE SHIFTER TO BE MOVED OUT OF THE PARK POSITION WITH THE KEY REMOVED. AN INOPERATIVE INTERLOCK MAY ALSO ALLOW THE KEY TO BE REMOVED WHEN THE SHIFTER HAS NOT BEEN PLACED IN THE PARK POSITION.
Remedy: DEALERS WILL INSTALL A NEW LOAD-LIMITING PUSH ROD INTO THE FLOOR SHIFTER LEVER OF THE AFFECTED VEHICLES. OWNER NOTIFICATION BEGAN ON JUNE 14, 2004. OWNERS SHOULD CONTACT DAIMLERCHRYSLER AT 1-800-853-1403.
FEDERAL-MOGUL IS RECALLING CERTAIN REPLACEMENT CONTROL ARM ASSEMBLIES, PART NUMBERS K7425, 10945, FA4510X, K7427, 10946, AND FA4611X, SOLD FOR USE ON VARIOUS PASSENGER VEHICLES LISTED ABOVE. THE BALL JOINT ON THE CONTROL ARM ASSEMBLY CAN FAIL CAUSING THE BALL STUD TO WEAR THROUGH THE CONTROL ARM HOUSING RESULTING IN NOISE AND/OR SEPARATION OF THE BALL STUD FROM THE HOUSING.
Remedy: FEDERAL-MOGUL WILL NOTIFY OWNERS OF RECORD AND REPLACE THE AFFECTED CONTROL ARMS FREE OF CHARGE. THE SAFETY RECALL BEGAN ON JANUARY 28, 2011. OWNERS MAY CONTACT FEDERAL-MOGUL AT 1-877-489-6659.
VEHICLE DESCRIPTION: PASSENGER VEHICLES. IF THE RUBBER BOOTS ON THE LOWER LATERAL ARM BALL JOINTS OF THE FRONT SUSPENSION WERE DAMAGED DURING ASSEMBLY, DIRT AND WATER CAN INTRUDE. ALSO, MMC HAS ADDED THE POTENTIAL OF LEAKING MOISTURE, WHICH CAN CAUSE THE BALL STUD TO CORRODE.
Remedy: DEALERS WILL INSPECT THE LOWER LATERAL ARM BALL JOINT FOR WEAR. BALL JOINTS THAT EXHIBIT WEAR BEYOND THE ESTABLISHED TOLERANCE WILL BE REPLACED WITH NEWLY DESIGNED LATERAL ARM BALL JOINTS. BALL JOINTS THAT ARE WITHIN THE ESTABLISHED TOLERANCE WILL BE CLEANED AND A SPECIAL SEALANT WILL BE APPLIED TO PREVENT INTRUSION OF MOISTURE.
SABERSPORT IS RECALLING 16,270 COMBINATION CORNER AND BUMPER LAMP ASSEMBLIES OF VARIOUS PART NUMBERS SOLD FOR USE AS AFTERMARKET EQUIPMENT FOR VARIOUS PASSENGER VEHICLES. THESE HEADLAMPS FAIL TO CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT." THESE LAMPS DO NOT CONTAIN THE REQUIRED AMBER SIDE REFLECTORS.
Remedy: SABERSPORT WILL NOTIFY OWNERS AND OFFER A FULL REFUND FOR THE NONCOMPLIANT COMBINATION LAMPS. THE SAFETY RECALL BEGAN ON MAY 11, 2009. OWNERS MAY CONTACT SABERSPORT AT 1-909-598-7589.
How other years compare
Check your exact Sebring by VIN
Recalls and equipment differ between individual vehicles. Decode your VIN to see what applies to yours.
Open VIN decoderFrequently asked questions
Is the 1999 Chrysler Sebring reliable?
NHTSA has 264 owner complaints and 12 recall campaigns on record for the 1999 Chrysler Sebring. The most complained-about area is structure (15% of complaints).
At what mileage do 1999 Chrysler Sebring problems usually appear?
Half of the complaints that mention mileage were filed at 81,500 miles or less.
Does the 1999 Chrysler Sebring have open recalls?
12 recall campaigns have been issued, the latest concerning suspension:front:control arm:lower ball joint. Check your specific vehicle by VIN - recall repairs are free at franchised dealers.
Source: NHTSA recall campaigns and owner complaints (public domain). Counts reflect reports on file and are not a defect rate.